Dextrose and Sodium Chloride Injection

Name: Dextrose and Sodium Chloride Injection

Dextrose and Sodium Chloride Injection Description

Dextrose and Sodium Chloride Injection, USP solutions are sterile and nonpyrogenic. They are large volume parenteral solutions containing various concentrations and combinations of these drugs in water for injection intended for intravenous administration.

See Table for summary of content and characteristics of these solutions.

The solutions contain no bacteriostat, antimicrobial agent or added buffer and each is intended only as a single-dose injection. When smaller doses are required the unused portion should be discarded.

The solutions are parenteral fluid, nutrient and electrolyte replenishers.

Dextrose, USP is chemically designated D-glucose monohydrate (C6H12O6 • H2O), a hexose sugar freely soluble in water. It has the following structural formula:

Sodium Chloride, USP is chemically designated NaCl, a white crystalline powder freely soluble in water.

Water for Injection, USP is chemically designated H2O.

The flexible plastic container is fabricated from a specially formulated polyvinylchloride. Water can permeate from inside the container into the overwrap but not in amounts sufficient to affect the solution significantly. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials. Exposure to temperatures above 25°C/77°F during transport and storage will lead to minor losses in moisture content. Higher temperatures lead to greater losses. It is unlikely that these minor losses will lead to clinically significant changes within the expiration period.

Indications and Usage for Dextrose and Sodium Chloride Injection

Intravenous solutions containing dextrose and sodium chloride are indicated for parenteral replenishment of fluid, minimal carbohydrate calories, and sodium chloride as required by the clinical condition of the patient.

Warnings

Solutions containing sodium ions should be used with great care, if at all, in patients with congestive heart failure, severe renal insufficiency and in clinical states in which there exists edema with sodium retention.

Excessive administration of potassium-free solutions may result in significant hypokalemia.

In patients with diminished renal function, administration of solutions containing sodium ions may result in sodium retention.

The intravenous administration of these solutions can cause fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, overhydration, congested states or pulmonary edema.

The risk of dilutional states is inversely proportional to the electrolyte concentrations of administered parenteral solutions. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentrations of such solutions.

Precautions

Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations and acid-base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation.

Solutions containing dextrose should be used with caution in patients with known subclinical or overt diabetes mellitus.

Caution must be exercised in the administration of parenteral fluids, especially those containing sodium ions to patients receiving corticosteroids or corticotropin.

Do not administer unless solution is clear and container is undamaged. Discard unused portion.

Pregnancy Category C. Animal reproduction studies have not been conducted with dextrose or sodium chloride. It is also not known whether dextrose or sodium chloride can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Dextrose or sodium chloride should be given to a pregnant woman only if clearly needed.

Pediatric Use. The safety and effectiveness in the pediatric population are based on the similarity of the clinical conditions of the pediatric and adult populations. In neonates or very small infants, the volume of fluid may affect fluid and electrolyte balance.

Frequent monitoring of serum glucose concentrations is required when dextrose is prescribed to pediatric patients, particularly neonates and low birth weight infants.

In very low birth weight infants, excessive or rapid administration of dextrose injection may result in increased serum osmolality and possible intracerebral hemorrhage.

Geriatric Use. An evaluation of current literature revealed no clinical experience identifying differences in response between elderly and younger patients. In general, dose selection for an elderly patient should be cautious, usually starting at the low end of the dosing range, reflecting the greater frequency of decreased hepatic, renal, or cardiac function, and of concomitant disease or other drug therapy. Sodium ions are known to be substantially excreted by the kidney, and the risk of toxic reactions may be greater in patients with impaired renal function. Because elderly patients are more likely to have decreased renal function, care should be taken in dose selection, and it may be useful to monitor renal function.

How is Dextrose and Sodium Chloride Injection Supplied

Dextrose and Sodium Chloride Injection, USP are supplied in single-dose flexible plastic containers in various sizes and concentrations as shown in the accompanying Table.

Content and Characteristics

Grams/100 mL

Per 1000 mL

NDC No.

Product

Dextrose

(hydrous)

Sodium

Chloride

Sodium

Na+

Chloride

Cl¯

Caloric

Value

Tonicity

Osmolarity mOsmol/L (calc)

pH

Container

size (mL)

0409-7924-02

5% Dextrose and 0.225% Sodium Chloride Inj., USP

5

0.225

38.5 mEq

38.5 mEq

170

Hypertonic

329

4.3 (3.5 to 6.5)

250

0409-7924-03

5% Dextrose and 0.225% Sodium Chloride Inj., USP

5

0.225

38.5 mEq

38.5 mEq

170

Hypertonic

329

4.3 (3.5 to 6.5)

500

0409-7924-09

5% Dextrose and 0.225% Sodium Chloride Inj., USP

5

0.225

38.5 mEq

38.5 mEq

170

Hypertonic

329

4.3 (3.5 to 6.5)

1000

0409-7925-02

5% Dextrose and 0.3% Sodium Chloride Inj., USP

5

0.3

51 mEq

51 mEq

170

Hypertonic

355

4.3 (3.5 to 6.5)

250

0409-7925-03

5% Dextrose and 0.3% Sodium Chloride Inj., USP

5

0.3

51 mEq

51 mEq

170

Hypertonic

355

4.3 (3.5 to 6.5)

500

0409-7925-09

5% Dextrose and 0.3% Sodium Chloride Inj., USP

5

0.3

51 mEq

51 mEq

170

Hypertonic

355

4.3 (3.5 to 6.5)

1000

0409-7926-02

5% Dextrose and 0.45% Sodium Chloride Inj., USP

5

0.45

77 mEq

77 mEq

170

Hypertonic

406

4.3 (3.5 to 6.5)

250

0409-7926-03

5% Dextrose and 0.45% Sodium Chloride Inj., USP

5

0.45

77 mEq

77 mEq

170

Hypertonic

406

4.3 (3.5 to 6.5)

500

0409-7926-09

5% Dextrose and 0.45% Sodium Chloride Inj., USP

5

0.45

77 mEq

77 mEq

170

Hypertonic

406

4.3 (3.5 to 6.5)

1000

0409-7941-02

5% Dextrose and 0.9% Sodium Chloride Inj., USP

5

0.9

154 mEq

154 mEq

170

Hypertonic

560

4.3 (3.5 to 6.5)

250

0409-7941-03

5% Dextrose and 0.9% Sodium Chloride Inj., USP

5

0.9

154 mEq

154 mEq

170

Hypertonic

560

4.3 (3.5 to 6.5)

500

0409-7941-09

5% Dextrose and 0.9% Sodium Chloride Inj., USP

5

0.9

154 mEq

154 mEq

170

Hypertonic

560

4.3 (3.5 to 6.5)

1000

Protect from freezing. Store at 20 to 25°C (68 to 77°F). [See USP Controlled Room Temperature.]

Revised: June, 2009

Printed in USA                                                     EN-2179

Hospira, Inc., Lake Forest, IL 60045 USA

PRINCIPAL DISPLAY PANEL - 1000 mL Bag Overwrap - NDC 0409-7924-09

2
HDPE

TO OPEN TEAR AT NOTCH

DO NOT REMOVE FROM OVERWRAP UNTIL READY FOR USE. AFTER REMOVING
THE OVERWRAP, CHECK FOR MINUTE LEAKS BY SQUEEZING CONTAINER FIRMLY.
IF LEAKS ARE FOUND, DISCARD SOLUTION AS STERILITY MAY BE IMPAIRED.
RECOMMENDED STORAGE: ROOM TEMPERATURE (25°C). AVOID EXCESSIVE
HEAT. PROTECT FROM FREEZING. SEE INSERT.

98-4321-R14-3/98

(web3)